| MCU |
STM32F745 |
| IMU(Gyro) |
MPU6000 |
| USB Connection |
Need to solder a USB TYPE-C module to D+,D-,GND pads. |
| Barometer |
BMP280 |
| OSD |
Supported |
| BLE Bluetooth |
Supported. Used for parameter configuration |
| Flash FC Firmware Wirelessly |
Supported |
| Download/Analyze Blackbox |
Supported |
| DJI Air Unit 6-pin Connector |
Built-in. |
| Flash(for BlackBox) |
8MB |
| Current Sensor |
Supported. Scale=256 |
| BetaFlight Camera Control Pad |
Yes(CC pad) |
| 5V Output |
4 groups of 5V output. The total current load is 2.5A. |
| 9V Output |
None |
| 3.3V Output |
Supported. Up to 500mA current load. |
| ESC Signal Pads |
M1 - M4 |
| UART |
Full UART * 4(UART1, UART2, UART3,UART4) |
| ESC Telemetry UART |
None |
| I2C |
Supported. |
| LED Pad |
Used for WS2812 LED |
| Buzzer |
BZ+ and BZ- pad used for 5V Buzzer |
| BOOT Button |
Used to enter DFU mode |
| RSSI Input |
Not supported |
| SmartPort |
Use any TX pad of UART for the SmartPort feature. |
| Supported Flight Controller |
BetaFlight(Default) |
| Firmware Firmware Target Name |
SPEEDYBEE F745AIO |
